![]() *** In Client Bridged mode the WAN is disabled anyway Time Zone: Local DNS: *** Only if you don't have internet set it to the same as Gateway Maybe for someone else better will be to use the IP address of their main address. Set the wireless network name exactly the same as your primary router. If you are using N-only or Mixed with N, set your wireless channel width to match the primary. The wireless network mode, channel, and encryption match the primary router settings. *** These also the recommended settings by DD-WRT, so don’t use TKIP. *** For us best worked on both routers (the main and this – the client) Security Mode: WPA2-PSK Wireless => Wireless SecurityĪnd set the security type and key from the primary router. *** Or to any other IP that you set in previous step. If your main router on 10.0.0.138, so make it the next on the same subnet, like: “10.0.0.139”. *** Your main router is likely to be 192.168.1.1, so you won’t be able to connect to this one in order to view the configuration page. Login to the web interface at “192.168.1.1”. How to setup Client Bridge mode on D-Link DIR 615 E4 *** You might also consider reading about “ Repeater Bridge” mode if you need more tips in settings. Setting up Client Bridge is different on all the chipsets – for us it worked. You can read more about Client Bridged Description in the wiki. If we have another computer that we want to connect wirelessly, it should not work, because this mode is intended for routers only. For example, Computer 1 connects to the main router with wire, then main router connects to the secondary router wirelessly (this is the only wireless connection allowed, one router to another) and lastly the second computer connects by wire to the secondary router. The purpose is to connect wired computers “wirelessly”. “Client Bridged” mode is a hack by DD-WRT team and may cause instability in your production environment. There are many other methods – you can get familiar with them from Linking Routers DD-WRT wiki database and Repeating Mode Comparisons. For our particular purpose we needed to setup “Client Bridged” Repeating Mode. You may check our article on how to install DD-WRT to D-Link DIR 615 E4 router. To achieve this setting, it was only possible by flashing custom firmware and we chose DD-WRT. Our goal was to set D-Link DIR 615 E4 to connect to our wireless network so we could connect to it our wired computer for different purposes: Wakeup-On-LAN, Backup to a wireless network card for this particular computer. What is DD-WRT Wireless Client Bridge mode ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |